Why onsite support helps before removal
When a motor or drive starts tripping, running hot, or sounding different, an onsite visit can show whether the issue is local to the machine, the supply, or the driven equipment. That saves time on the wrong removals and helps the repair plan start with proper information.
Our team supports plants and workshops in Germiston, Johannesburg, Ekurhuleni, Pretoria, Vereeniging and Durban, with work planned around shutdown windows and production pressure. In many cases the first step is a practical check on site, then clear advice on what should stay in place, what needs testing, and what must come back to the workshop.
What we look at on site
Onsite checks are there to gather facts before anyone opens equipment up or orders parts. We look for signs that point to winding damage, bearing wear, poor connections, moisture ingress, overload, misalignment, or problems on the drive side. If the fault is electrical, the equipment must be isolated and locked out by qualified people before any testing starts.
- Fault finding on motors and variable speed drives
- Motor removal planning where workshop repair is needed
- Drive inspection and panel cleaning
- Bearing checks and basic alignment checks
- Insulation testing and cable checks where appropriate
Planning isolation and shutdowns safely
Good support is not only about the machine, it is also about the work method. We help coordinate isolation steps, shutdown planning and site reporting so the job can be handed over cleanly to the right people. That matters on sites with multiple machines, shared feeds, backup supplies, or equipment that cannot be left in an uncertain state.
Where a motor has to be removed, we can help plan access, lifting points, spares assessment and the sequence of disconnecting cables, guards and couplings. This is especially useful on busy sites in Gauteng and coastal areas where humidity, dust and load-shedding can all affect the condition of equipment.
- Lockout procedures before inspection or testing
- Clear isolation steps for motors, panels and drives
- Shutdown planning for short maintenance windows
- Site reporting for maintenance teams and supervisors
Condition checks that guide the repair
Not every fault means a full rewind. Sometimes the issue is a failed bearing, contaminated connections, damaged cables or a drive that needs inspection and repair. Other times the motor windings show insulation weakness, heat damage or contamination that points to workshop work. A proper onsite look helps separate these possibilities before the equipment is moved.
We also check for signs that can affect the repair outcome, such as poor ventilation, soft foot, misalignment, blocked panels or recurring overloads. That information helps the repair team choose the right approach and avoid repeat failures after recommissioning.
Workshop handover after the site visit
Once the onsite assessment is complete, the next step is a clean handover to the repair team if removal is needed. That may include notes on the symptoms, photos, cable marks, terminal positions, nameplate details and any site conditions that could have contributed to the fault. Small details matter, and a missing terminal label or loose gland can slow a job down.
For customers with several machines running at once, this handover makes it easier to prioritise what must be repaired first and what can wait. It also helps maintenance teams keep records that are useful for future outages, especially where the same motor or drive has shown repeat issues.
Who this service suits
Onsite support is useful for factories, workshops, pumping installations, food plants, warehousing, and processing sites that need practical help before a unit is removed. It is also suitable where the fault is not obvious, where access is awkward, or where a second opinion is needed before downtime gets worse.
- Sites needing motor condition checks before removal
- Plants with variable speed drive faults or panel issues
- Operations that need shutdown planning and isolation support
- Teams that want clear fault notes before workshop repair
Locor’s Germiston base supports work across South Africa, with regular service into Johannesburg, Ekurhuleni, Pretoria, Vereeniging, Durban, Boksburg and Kempton Park. If the fault needs a site visit first, our enquiry form on the contact page is the best way to start.